Dingfeng Capacitor--What is the function of inductors and capacitors?

Capacitors store electric energy when they are connected to a battery or some other charging circuit. They are commonly placed in electronic components and are used to maintain a power supply while the device is unplugged and without a battery for a short time. The energy within the capacitor prevents the loss of data, with an example being the RAM of a computer.The capacitor contains two metallic plates that are separated by some form of insulation. The plates store the energy until it is needed.There are different types of capacitors:Axial electrolyc, small, low voltage, general purpose capacitor High voltage disk ceramic: small size with high tolerance. High voltage electrolyc: used in power supplies Metalized polypropylene: small size, good for up to 2 microfarad Multi-layer: surface mount, high capacitance The capacitance refers to the amount of storage capacity available. Capacitance is usually measured in the farad unit, which is the equivalent of one coulomb per volt. A coulomb is the unit of electrical charge. Both farad and coulomb are identified as standards by the International System of Units. For the capacitors in household electrical components, the capacitance can be measured in micro farad.

An inductor, also called a coil or reactor, is a passive two-terminal electrical component which resists changes in electric current passing through it. It consists of a conductor such as a wire, usually wound into a coil .Energy  is stored in a magnetic field in the coil as long as current flows. When the current flowing through an inductor changes, the time-varying magnetic field induces a voltage in the conductor, according to Faraday’s law of electromagnetic induction.According to Lenz's law the direction of induced electromotive force(or "e.m.f.") is always such that it opposes the change in current that created it. As a result, inductors always oppose a change in current, in the same way that a flywheel opposes a change in rotational velocity. Care should be taken not to confuse this with the resistance provided by a resistor.